| T.R | Title | User | Personal
Name | Date | Lines |
|---|
| 475.1 | reversed [inside] wires will reverse servo | ABACUS::RYDER | perpetually the bewildered beginner | Tue Feb 20 1990 07:14 | 5 |
| The leads from the rcvr to servo are not touched. The leads from
servo electronics to servo motor/pot can be reversed. I'll see
if I can find the details.
Hmmn. X months x Y subscriptions = ? magazines
|
| 475.2 | used to build these things | SRATGA::HUFF_DO | | Tue Feb 20 1990 14:05 | 10 |
|
UNLESS SERVOS HAVE GONE INTO THE OUTER LIMITS:
1.Reverse the two outside pot wires.
2.Reverse the two motor brush wires
3.Recenter servo at servo using whatever is designated, usually
a tool to slip pot wiper on its driver shaft. Remote pot might me
a gear tooth remate.
don
|
| 475.3 | there's the ol' tried and true method | LEDS::COHEN | Some limitations may apply... | Wed Feb 21 1990 13:25 | 1 |
| why not just move the linkage to the other side of the servo wheel?
|
| 475.4 | Do the Tx not the servo! | ULYSSE::FROST | | Tue Apr 17 1990 07:27 | 6 |
| New to this notes file but an avid modeller since I was knee-high
to a sparrow.
Simplest method of all, is to reverse the POT -ve and +ve leads
on the TRANSMITTER! Don't touch the center lead.
Of course this reverses all servos running off the reversed channel.
|