Conference mvblab::sable

2540.0. "no mouse interrupt, no graphics console driver installed" by KOOLIT::MCDOWELL () Fri Feb 28 1997 08:24

   
   I have looked through this notes conference and found nothing that is
   close to our problem.


   We just upgraded our two AS 2000 I/O backplanes (B2111-AA) from Rev. E01
   to H01 so we can run Memory Channel and TruCluster Production Server.

   After installing the backplanes, upgrading the firmware, etc., one
   system comes up with a graphics display problem.  System boots, etc, but
   CDE does not display.

   At the console level, after an >>> init, we get the following error:

           ** no mouse interrupt **

   During boot to DUX 4.0B, see the following message that is also shown
   with uerf -r 300:


   No graphics console driver installed
   generic console support installed:  using VGA


   Kernel has been rebuilt, and all the CDE and FONT subsets are installed.

   At single-user and multi-user mode, we are able to use the monitor (like
   a serial console) for a short time then it will not accept any keyboard
   input.

   I have swapped the monitor, keyboard, and mouse between systems.  I
   suspect a DOA B2111 I/O backplane ROM.


   Before I start swapping modules and the I/O backplane has anyone got any
   ideas to help isolate the problem?


   Thanks,

   bob