| I think Neil is out for a few days so I'll attempt to help.
� same subnet mask 255.255.255.252. I was unable to ping to the cisco ip add.
� from both side.
So did the RA think the FR network was up?. Check the following:
* t 5
+conf
+int 1
This should indicate if the link is up. Did you fully configure the FR
interface on the RA (Line speed, LMI type)?. Did the FR sub-system report
any events:
* t 6
Config>events
ELS Config>disp sub frl all
* restart
� 1. Do they have any interoperability issue ?
� 2. if not can the two ser. port on the same subnet. ( if both side is Cisco
� , they are do it, according to customer)
� 3. if possible plese advise how to configure and make it work?
You might also like to look through this conference for further details.
Mark
|