| Title: | DIGITAL UNIX (FORMERLY KNOWN AS DEC OSF/1) |
| Notice: | Welcome to the Digital UNIX Conference |
| Moderator: | SMURF::DENHAM |
| Created: | Thu Mar 16 1995 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 10068 |
| Total number of notes: | 35879 |
Hello,
We have encountered a problem in adding a DWLPA-CA to an AS8200
system.The console was upgraded to V3.1-6 from the V3.6 f/w CD
as the DWLPA-CA had the later motherboard fitted.
The DWLPA-CA has 2 x KZPSA at rev A10 fitted,an HSZ40 was connected
to each KZPPSA in turn and all of the appropriate disks could be
seen at the console level.NO power up errors were experienced.
The system is running DECunix V3.2c,on booting the system crashes
with :
panic ( cpu 10 ) : pciaconfl : get_bus failed
The pci shelf was removed and the system boots fine.
There have been a couple of similar entries in this and the
Turbolaser conference,I would be grateful for help with the
above.
tony melling
( Warrington UK )
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 8780.1 | Did you boot w/genvmunix to re-doconfig? | SMURF::DUTILE | OSF Eng., HW Support | Tue Feb 11 1997 12:24 | 16 |
After adding the dwlpa-ca, did you run the generic kernel to re-config? if not, then the panic message is correct. your target kernel is sized to only support the devices that existed on the system when the kernel was installed on it. to re-build a new target kernel, boot w/genvmunix and run doconfig. Let us know if you did or did not run genvmunix. - Don =============================================================== | |||||
| 8780.2 | WARFUT::MELLING | Thu Feb 13 1997 04:38 | 14 | ||
Hello,
Thanks for the prompt reply,we did not try booting with
genvmunix.
The customer's concern was to get their system back up
and research the problem.
I shall advise the customer of the above and post you the
results.
regards
tony
| |||||