| Well the system has failed with cache version mis-match errors again,
and this time is down hard. The BA350-MA box has been replaced to
eliminate this as a possible cause. The BA350-MA has dual BA35X-HF
power and is running V5.0 in each of the HSZ50's. Each controller
has 64meg cache. There is external batteries. Here is a snap of the
error sequence. Disregard any shelf fan or power supply bad errors, as
only one power controller is plugged in.
%EVL--Left_HSZ50> --13-JAN-1946 04:32:54 (time not set)-- Instance
Code: 0102030A (not yet reported to host)
Template: 1.(01)
Occurred on 23-FEB-1997 at 10:47:50
Power On Time: 0. Years, 51. Days, 19. Hours, 16. Minutes, 33. Seconds
Controller Model: HSZ50-AX
Serial Number: ZG63300556 Hardware Version: A01(01)
Firmware Version: V50Z(50)
Informational Report
Instance Code: 0102030A
Last Failure Code: 20080000 (No Last Failure Parameters)
%EVL--Left_HSZ50> --13-JAN-1946 04:32:54 (time not set)-- Instance
Code: 02072201 (not yet reported to host)
Template: 20.(14)
Power On Time: 0. Years, 51. Days, 19. Hours, 16. Minutes, 33. Seconds
Controller Model: HSZ50-AX
Serial Number: ZG63300556 Hardware Version: A01(01)
Firmware Version: V50Z(50)
Reported via non-maskable interrupt
Memory Address: 00000000
Byte Count: 0.(00000000)
DRAB Registers:
DSR: 20136830 CSR: 201385C0 DCSR: 20138C40 DER: 20138B60 EAR:
20136780
EDR: 20138B60 ERR: 20138B60 RSR: 20083E30 CHC: A4FCFCFD CMC:
20B8FEF0
Diagnostic Registers:
RDR0: A4FCFCFD RDR1: 20B8FEF0 WDR0: 7F0397B0 WDR1: FF0E020D
Instance Code: 02072201
Left_HSZ50> SHO THIS
Controller:
HSZ50-AX ZG63300556 Firmware V50Z-1, Hardware A01
Not configured for dual-redundancy
Controller misconfigured -- other controller present
SCSI address 7
Time: NOT SET
Host port:
SCSI target(s) (0, 1, 2), Preferred target(s) (0)
TRANSFER_RATE_REQUESTED = 10MHZ
Cache:
Unknown size read cache, version unknown
Cache is FAILED
Host Functionality Mode = D
Cache module failed diagnostic testing of memory controllers
Controllers misconfigured. Type SHOW THIS_CONTROLLER
Left_HSZ50> set failover copy=this
Error 6130: Both caches must be at version 3. This cache is at version
4294967295,
the other cache is at version 0
Right_HSZ50>
Right_HSZ50> set failover copy=this
Error 6130: Both caches must be at version 3. This cache is at version
4294967295,
the other cache is at version 0
Right_HSZ50>
Right_HSZ50>
-Lee
|