Conference 7.286::postscript_printing

7214.0. "Yellow dots on LNC01 (Colorwriter LSR 2000)" by UTOPIE::PUCHINGER_G (GERHARD PUCHINGER @AUI, DTN:*754/2553) Wed May 28 1997 11:22

    Hi,
    
    the LNC01 Colorlaserprinter is producing yellow dots all over the page.
    This has been seen up to now on three different printers as well from
    Mac as from Windows and also with the test page. It does NOT happen
    when printing the engine test pages or a black/white page.
    The dots are pixel dots and can only be seen with a 8 to 10 times
    magnifying glass. Most visible are the dots in the fading areas of the
    coloured bars of green, red or cyan.
    There is a margin on the paper, where no dots occur.
    
    I changed the simms due to that problem and was about to swap the video
    controller, as i noticed on the test print supplied with the board also
    the yellow dots. After this i checked the demo printer here at digital
    - also the same.
    
    Has anyone already seen this and can confirm it?
    Is there a soloution?
    
    
    Thanks and kind regards
    
    Gerhard Puchinger
    MCS Support Austria
    

    Please escalate this if you haven't already. This sounds very unusual
    to everyone I've spoken with here.