[Search for users]
[Overall Top Noters]
[List of all Conferences]
[Download this site]
| Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
| Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
| Moderator: | NETCAD::COLELLA DT |
|
| Created: | Wed Nov 13 1991 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4455 |
| Total number of notes: | 16761 |
4341.0. "VNSwitch EAs w/ FDDI Bridge Tunnel ... EF's Crash" by PRMS00::copras1_port11.cop.dec.com::cascio (Steve Cascio, PRMS00::cascio) Mon Apr 07 1997 23:18
I installed a pair of back to back VNSwitch EA�s & EF�s in a pair of
hubs today & did not get very far. The default configuration, as
installed, set up an Ethernet bridge tunnel between the two EA�s.
Since the end systems are FDDI based (Connected to the FDDI
Concentrators) I attempted to change the Ethernet Bridge tunnel
(i/f #28) to an FDDI bridge tunnel. The EAs accepted the change
just fine, but about 20 seconds after they initialized both
EF�s crashed. The EF�s reinit and then immediately crash again.
Removing the fiber between the EAs allowed the EFs to init w/o
crashing. Plug the fiber back in ... crash loop all over again.
What am I doing wrong/what am I missing?
Steve
--VN-- --VN--
| | | | | | | |
| C | E | E | | E | E | C |
| O | F | A | | A | F | O |
| N | | |=======| | | N |
| N | | | | | | N |
| | | | | | | |
-BCK PLN- -BCK PLN-
Module Firmware:
EA & EF 1.5
MAM 5.0