[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

4333.0. "VNswitch MIB II support?" by NETRIX::"[email protected]" (Roland Fueglister) Thu Apr 03 1997 07:21

I had the opportunity to access a VNswitch 900EE/V1.5 via NetView 
SNMP MIB browser and the following MIB variables were always "0",
despite the corresponding packet counters were continously
increasing:

- interfaces.ifTable.ifEntry.ifInOctets  
- interfaces.ifTable.ifEntry.ifOutOctets

Are these MIB variables NOT implemented? I was seeking through the
release notes, etc, and I haven't found anything.

best regards,

Roland
  
[Posted by WWW Notes gateway]
T.RTitleUserPersonal
Name		DateLines
4333.1no byte counters at this timeNETCAD::FLOWERSHigh Performance Networking; DanThu Apr 03 1997 10:169
>- interfaces.ifTable.ifEntry.ifInOctets  
>- interfaces.ifTable.ifEntry.ifOutOctets

Unfortunately, at this time, the VNswitch hardware is not able to
accumulate byte counters for traffic.  Thus these counters are always
zero.  The only thing you can to monitor utilization at this time is packet
counters.

Dan