[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

3267.0. "2 FDDI rings on DEChub 900" by DABEAN::B_ROSE () Mon Feb 12 1996 09:40

    I am installing a DECHUB 900 MultiSwitch with four DECconcentrator
    900MX. This is a standalone HUB which will have 6 AXP VMS machines
    attatched. We need to have a primary and a secondary FDDI ring on
    this setup. Being illiterate when it comes to the new network 
    equipment I would appreciate a pointer or two on how to setup the
    two rings. 
    
    I have gone through this notes file and there is a lot of information
    presented and I'm sure my answer is in there, but I can't understand
    half of what I am reading. 
    
    Thanks
    
    Bruce
T.RTitleUserPersonal
Name
DateLines
3267.1NETCAD::DOODYMichael DoodyMon Feb 12 1996 10:539
    You could start with the FDDI configuration guide in note # 2340.
    
    Not sure what you mean by primary and secondary. Perhaps you mean dual
    homing. In that case you'd connect all the concentrators together in
    a dual ring in the hub backplane with Hubwatch, then connect each port
    of the DAS on the workstations to a different concentrator, thus
    gaurding against a fault in any one concentrator or cable.
    
    -Mike
3267.2STRWRS::KOCH_PIt never hurts to ask...Mon Feb 12 1996 15:046
    I agree with Michael in .1, but to really make it fault tolerant, put
    dual controllers in the AXP machines. Even with FDDI dual homing and
    N+1 power in the DEChub, the NIC card is still a single point of
    failure, regardless of whether it's a DAS card. DAS simply provides
    path redundancy, but two controllers along with items mentioned in .1
    provide total redundancy.
3267.3HUBwatchFREEBE::B_ROSETue Feb 13 1996 06:127
    It sounds as the HUBwatch software is required to set up the "dual"
    rings. I copied down the notes entry mentioned and will go through it
    before I try anything else. As for the second card .. it'd be nice, but
    we have gone almost two years without a "glitch" with the card in there
    so it'd be tough to sell them a second card.
    
    Bruce