Conference netcad::hub_mgnt

3231.0. "DR900GM - won't update through Hub" by SCCAT::MILLER () Fri Feb 02 1996 14:45

    I have some DECrepeater 900GM's that are exhibiting a strange problem.
    When I try ro update their firmware from V1.1 to V2.0 using the Hub,
    I get the message "Hub managed loads not supported for this module,
    use direct loading".  This is happening on 3 900GM's in 2 hubs.  In
    one of the hubs, I have 4 other 900GM's that loaded just fine using
    the hub.  Two of the 900GM's loaded fine using the direct method,
    but still won't load using the hub.  One of them won't load at all,
    so it's probably broke.  All of them are new, straight out of the
    box.  Both hubs are V4.1.
    
    What mechanism tells Hubloader what the module is (besides the
    SNMP getresponse, which is the same for good and bad 900GM's)?
    What tells hubloader that a module can be loaded through the
    MAM?
    
    Thanks

    I would appreciate any info anyone can give me on this.
    
    Thanks!!