| Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
| Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
| Moderator: | NETCAD::COLELLA DT |
| Created: | Wed Nov 13 1991 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4455 |
| Total number of notes: | 16761 |
Hi!
A customer has a DEChub 900MS (V4.1.0) populated with a DECserver 90M
(slot 1), a DECrepeater 90C (slot 2) and a DECswitch 900EF (slot 8 -
V1.5.2) that works perfectly except that the LCD display has permanently
EXCEPT V0=08 SR=2700 PC=00601AA4:FAILED
Apparently, meaning from HUBwatch and connection-wise everything else
is OK. I asked the customer to dump the error log for me to see if it
reports anything (will get it tomorrow). Any idea of what's going on ?
Pedro
PS: The customer says that if he powers down & up the hub the display
will disappear but will come again later.
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 3026.1 | NETCAD::DOODY | Michael Doody | Tue Dec 05 1995 09:43 | 6 | |
If that message is displayed permanently, then the hub manager (MAM)
cannot be running. The PC address could indicate a hardware diagnostic
failure. Find out if the MAM ever reaches the "Selftest Complete
Start Main Firmware" message.
-Mike
| |||||
| 3026.2 | MAM defect | LEMAN::PAIVA | Hawkeye - Network Support @GEO | Tue Dec 05 1995 10:33 | 14 |
RIP dear MAM!
Had a message from the customer first thing in the morning. When he
went there to dump the error log, the message would be continuously
displayed immediatly after power up, so he decided to change the MAM module
at 5 A.M. and the problem "disappeared".
To answer your question (.1) the "Selftest Complete..." is never
reached as it hangs in the selftests (that's why the customer decided
to swap - he had a spare hub - the MAM module).
Thanks.
Pedro
| |||||