Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
Moderator: | NETCAD::COLELLA DT |
Created: | Wed Nov 13 1991 |
Last Modified: | Fri Jun 06 1997 |
Last Successful Update: | Fri Jun 06 1997 |
Number of topics: | 4455 |
Total number of notes: | 16761 |
I have a customer that gets the following message when launching Hubwatch from Polycenter Netview. Getting error message on launch as follows. In DX console (error display for Polycenter) File:/user/capitol_ou/reg /c/hubwatch_reg Line:50 Error unknown field "is dechub" Any ideas about this message, if anyone needs more I can contact the customer. Brad Lewis US/CSC
T.R | Title | User | Personal Name | Date | Lines |
---|---|---|---|---|---|
2996.1 | Someone edit the file? | NETCAD::FORINO | Mon Nov 27 1995 12:52 | 13 | |
First off - is the HUBwatch application entry enabled (not greyed out) for the device you want to launch HUBwatch against. If it is greyed out, then read the release notes about what must be done to enable HUBwatch. If it is not greyed out check line 50 in the registration file - I believe it is the selection rule line and should have an entry like SelectionRule isDEChub; I'm wondering if someone may have edited the file and changed isDEChub to what the error is giving you. That could be reason for the error. John | |||||
2996.2 | more info | CSC32::D_PERRIN | Fri Dec 01 1995 18:23 | 16 | |
More info from the customer: He says that Hubwatch by itself starts and runs fine. It's when he tries to start up Polycenter Netview that he gets the "unknown field" error. So he never sees Hubwatch either: 1. as a pull-down application selection under the Monitor entry in the Menu Bar 2. as a pull-down application selection under the Monitor when hitting MB3 over a symbol in the map He did NOT edit the hubwatch_reg file. I'm having him fax me this file. Does anybody have a pointer to one of these that I can look at? At the moment we don't have a Unix box to install this on. |