[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

2970.0. "DECconcentrator 900MX upgrade failed" by DECPRG::KUPKA () Mon Nov 13 1995 05:04

    During the upgrade of several hubs. concentrators, switches,.. from
    version 3.1 to 4.1 with HUBloader on concentrator failed. The load was
    done via MAM and after succesful download (as HUBloader sad) the modul
    was displayed as SW=unknown. The hub display shows concentrator as
    "programloadneeded".
    I know from this conference, that i.e. DECswitch 900EF can be loaded
    via port 2 from the BOOTP server.
    
    Do I have the same posibility with DECconcentrator 900MX? 
    
    Thanks,
    Tomas
T.RTitleUserPersonal
Name		DateLines
2970.1NETCAD::DOODYMichael DoodyMon Nov 13 1995 15:368
    Okay, just try the MAM assisted load again. It will take a minimum of 
    9 minutes to complete.  Make sure you wait long enough for the whole 
    process to complete. Once the firmware is loaded to the MAM it must
    then send it to the concentrator as a second step. Maybe hubloader was
    saying the the first part was done.
    
    
    -Mike
2970.2Hmmm.DECPRG::KUPKAWed Nov 15 1995 10:348
    Hmmm. If I have got a message FILE_WRITEN_TO_LINE_CARD during the
    device pool, I would expect everything was written. The messages on the
    hub display say something like loading, assisted load finished, status
    unknown (device reset) and than needprogramload.
    
    Anyway, thanks. We swapped the module.
    
    Tomas
2970.3NETCAD::DOODYMichael DoodyWed Nov 15 1995 10:473
    Hmmm.. Sounds like you did the right thing. Could be the flash was bad.
    
    md