| Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
| Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
| Moderator: | NETCAD::COLELLA DT |
| Created: | Wed Nov 13 1991 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4455 |
| Total number of notes: | 16761 |
I'm having a peculiar problem with V4.0 of the hub firmware. I'm a
System Engineer who carries a hub around for customer demos. I've
noticed since I've upgraded to V4.0 of the firmware that the settings
on my DEChub go away when the hub is powered down for a while. This did
NOT happen with V3.1. Can someone explain why this happenning?
I've lost my IP addresses and most recently my defined LANs were gone
when I powered it back up after about a week.
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 2558.1 | NETCAD::DOODY | Michael Doody | Wed Jul 26 1995 09:12 | 13 | |
It would be easier to tell if you showed us your errorlog entries
for the hub.
Since you said it didn't happen with v3.1 I assume you do all the right
things such as power the hub down after waiting 15 seconds after the
last change to the hub, power down before removing modules, make sure
the exact same modules go in the exact same slots when you set up
before the next powerup, etc. (that's for lan connections not IP
addresses, they should always be there).
-Mike
| |||||
| 2558.2 | STRWRS::KOCH_P | It never hurts to ask... | Wed Jul 26 1995 11:12 | 7 | |
Ok, I'll try that sequence and see what happens. When I was running
V3.1, no matter what I did, the IP address stayed set and the LANs were
there, although the connections went away because I didn't always put
them in the same slots.
| |||||