[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

2286.0. "firmware for win31 install fail" by TPOVC::FREDTSENG () Wed May 17 1995 07:03

    Hello!
    I had copied the firmware kit from netcad::proj$722:[onehub.release.
    firmware.v1_1.dos.disk2] completely. Then I used ftp (set binnary)
    to transfer to PC successly. All seems go smoothly. But when I
    installed the kit find it can't be done successfully when swap "disk2"
    flopy. Is there any problem in it or any suggestion? Need help!
    
    Thanks.
    FRED.
T.RTitleUserPersonal
Name		DateLines
2286.1DocumentedROGER::GAUDETBecause the Earth is 2/3 waterWed May 17 1995 08:5512
The problem is likely with the disk label.  The second disk needs to have a
label of "DCF_2" for the installation procedure to recognize it.  For
instructions on how to build a kit from the network respository, see:

	NETCAD::PROJ$722:[ONEHUB.RELEASE.FIRMWARE.V1_1.DOS]DISKBLD.TXT

Instructions for labeling disks are included.

FYI, this problem has been resolved for the next version of the consolidated
firmware kit.

...Roger...
2286.2install dcf on win31 successTPOVC::FREDTSENGWed May 17 1995 22:096
    Hi ROGER:
     I had label the disk2 and install again. This do work well.
    
    Thanks.
    Fred.