| T.R | Title | User | Personal
Name | Date | Lines |
|---|
| 2126.1 | Counters valid? | ODIXIE::WELLONS | | Tue Mar 21 1995 13:16 | 2 |
| I also have a site where many of the ports show 50 to 85% collision
rates, is this normal. How should I interpert these speedometers.
|
| 2126.2 | Ring purger enable? | TKTVFS::KOBAYASHI_S | Seiki Kobayashi, Network support/JAPAN | Tue Mar 21 1995 21:06 | 20 |
| >1. Looking at a Dec Repeater 900TM port statistics.
> Hw 3 Ro V1 Sw V1.0G
> Some ports show a 30 - 50% collision rate. I have even seen
> ports with greater than 100% collisions.
I have experienced this problem in DR900TM V1.0G. I have even seen some ports
that didn't connect any devices indicated 100% collisions. I checked with LAN
analyzer then I found that the DR900TM sent false counter value to HUBwatch.
We upped the version from V1.0G to V1.1 then this problem was fixed.
>2. When looking at the FDDI, traffic at times is over 35% utilization
> but I can't find any of the hubs that have anywhere near that
> ammount of traffic. Is ther any way short of a FDDI lan analzizer
> to determine the cause?
When you connect some digital's FDDI interfaces, these interfaces set Ring
purger enable initiatory. If the ring purger is enabled, then an average
traffic is over about 30% utilization.
Seiki
|
| 2126.3 | | IOOOOI::OHMAN | | Fri Mar 31 1995 11:10 | 11 |
| Thank you for the advice.
We have upgraded the DecRepeater900TM firmware to V1.1, we still see
about the same problem with collisions as before.
I have tried to disable Ring Purging on the FDDI ring, but can't find
instructions anywhare on how to check/change the DecBridge 620 DEFEB
Any further assistenance will be greatly appriciated
steve
|
| 2126.4 | | NPSS::WADE | Network Systems Support | Fri Mar 31 1995 13:59 | 16 |
| The MIB object is
dec ema decmibextension elanext efddi efddimac efddimactable (1,1) -
emacringpurgerenable
( defaults to 1(true)
set to 2(false) )
Or using DECmcc Bridge AM
set bridge xxx line 1 ring purger enable flag = false
Bill
|
| 2126.5 | | IOOOOI::OHMAN | | Fri Mar 31 1995 20:20 | 9 |
| Thank you Bill for the quick reqly, but could you please spell it
out in simple terms.
Now that I know the MIB object, how do I change it?
As far as I know Hubwatch is the only tool on site.
Steve
|
| 2126.6 | | NPSS::WADE | Network Systems Support | Mon Apr 03 1995 10:35 | 7 |
|
HUBwatch provides no support for the DEFEB. For the DEFEB you need
either the DECmcc Bridge AM or an SNMP NMS.
Bill
|