Conference netcad::hub_mgnt

2108.0. "ODI driver, some info" by PTOJJD::DANZAK (Pittsburgher �) Wed Mar 15 1995 07:09

    Attached in NET.CFG for an ODI set-up.  Wonderful things that I learned
    about it is that:
    
     - INDENTATIONS matter - be sure that you INDENT under each major item
    
     - LINK SUPPORT - the MAX STACKS is # of protocols that u can run, 
        eliminate the LINK SUPPORT and you can't have multiple stacks 
        under the LINK DRIVER (i.e. multiple protocol types etc.)
    
     - Under the LINK DRIVER area if you're running RAW 802.3 and
       ETHERNET-II - note that it did NOT like IPX specified in either.
       Specifying it in ONE seemed (Ethernet II) seemed to NOT make
       it work in RAW 802 above....so by leaving it UNSPECIFIED in
       both, IPX worked. (go figure)
    
    And, thank to the prior note in here and Tom Knight for info.
    
    
    
    
    
LINK SUPPORT
       MAX BOARDS      4
       MAX STACKS      11
       MEMPOOL         2K
       BUFFERS         2 1500

PREFERRED SERVER = fs3    **(Your server name here edit out between *)**

LINK DRIVER EPROODI
        PORT 300
        FRAME ETHERNET_802.3
        FRAME ETHERNET_II
;        PROTOCOL        IPX             8137    Ethernet_II
        PROTOCOL        DRP             6003    Ethernet_II
        PROTOCOL        NETBIOS         8040    Ethernet_II
        PROTOCOL        LAST            8041    Ethernet_II
        PROTOCOL        LAT             6004    Ethernet_II
        PROTOCOL        MOP             6002    Ethernet_II
        PROTOCOL        LOOPBACK        9000    Ethernet_II
        PROTOCOL        IP              0800    Ethernet_II
        PROTOCOL        ARP             0806    Ethernet_II
;
PROTOCOL TCPIP
       ip_address 1.1.1.2
       ip_netmask 255.255.255.0
       tcp_sockets 8
       udp_sockets 8
       raw_sockets 1
       nb_sessions 4
       nb_commands 8
       nb_adapter 0