| Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
| Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
| Moderator: | NETCAD::COLELLA DT |
| Created: | Wed Nov 13 1991 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4455 |
| Total number of notes: | 16761 |
Hi,
I was wondering if anyone else has been having any problems
installing the new version of the DEChub 900 firmware.
I used DECnet to copy the files from NETCAD::PROJ$722:[ONEHUB.
RELEASE.FIRMWARE.V1_1.DOS] (Actually the BACKUP utility so that the
subdirectories were created) to my system that has PATHWORKS file
services. I then copied the files from the file service to my drive
A with a newly formatted disk in it. I do a directory on drive A and
everything looks OK. The number of files and sizes match the list in
the directions detailing how to build the diskettes. When I attempt
to install the software I pull down the file menu and select run.
I enter a:\install and things look like they're OK. When I get
prompted for the second disk I put it in. I then keep getting a
message to place the second diskette in drive A. Apparently it isn't
recognizing the second disk. Again, if I do a directory listing - no
problem.
I've reformatted the disk several time and have copied the files
over several times as well.
Any suggestions?
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 1456.1 | Check out the instructions in DISKBLD.TXT | ROGER::GAUDET | Because the Earth is 2/3 water | Tue Sep 20 1994 16:34 | 7 |
You need to label the 2nd diskette "DCF_2" using the file manager's "Disk" pulldown and select the "Label Disk..." option. ...Roger... P.S. I have made a note to eliminate this restriction for the next release. | |||||
| 1456.2 | Thanks | OFOS01::HEBERTJ | Tue Sep 20 1994 16:49 | 5 | |
Hi Roger,
That fixed it. Thanks for the quick response.
Jim
| |||||