[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:	DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:	Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:	NETCAD::COLELLADT

Created:	Wed Nov 13 1991
Last Modified:	Fri Jun 06 1997
Last Successful Update:	Fri Jun 06 1997
Number of topics:	4455
Total number of notes:	16761

1404.0. "IP services conc mod, wrong on PNV/OV map" by ZPOVC::RAMARAJ () Mon Sep 12 1994 10:41

Customer has DEChub 900MS with 7 concentrators in it.
They are alll in the same ring.
All in a tree config using external ports.
Concentrators in slot 2-7 have individual address.  Slot 8 conc is IP services
for the hub.
Using slot 8 IP services address HW can see the whole hub and all conc.

From HP Openview or PNV the autodiscovery picks up conc in 2-7 in a ring 
in the same subnet.  
The slot 8 conc appears as a sperate network with no connection the ring, and
worst still appears as a segment.  It gives a wrong representation of 
the network.

If slot 8 conc is given a IP address and not used as an IP services module for
the hub, then all conc appear in the ring.

But this causes problem, because then Hubwatch only sees individual conc and 
not the whole hub.

How can this avoided, can the IP services conc module appear in the ring.

Raj
Singapore

T.R Title User Personal
Name Date Lines

1404.1 do both NACAD2::SLAWRENCE Mon Sep 12 1994 13:26 8

T.R	Title	User	Personal Name	Date	Lines
1404.1	do both	NACAD2::SLAWRENCE		`Mon Sep 12 1994 13:26`	8
	This may not directly answer your question, but may help... You can use the slot 8 (or any other) concentrator for IP services for the hub _and_ give it its own address; note that the two addresses must not be the same.

    
    This may not directly answer your question, but may help...
    
    You can use the slot 8 (or any other) concentrator for IP services for
    the hub _and_ give it its own address; note that the two addresses must
    not be the same.