[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

1367.0. "hubwatch v3 initialisation failure" by WPORPC::COURTMAN () Thu Sep 01 1994 02:31

I am trying to setup Hubwatch v3.0 (VMS) on a vax Station 3100/76. I have
installed ucx and Hubwatch started the relevent process BUT when I type 

	WATCH/AGENT "ip addres of decagent 90"

I get the following error
 
	"Hubwatch initisation error"

Any body got any ideas.

VMS ver 5.5-2

Regards

Rc
T.RTitleUserPersonal
Name		DateLines
1367.1Did it install ok?SLINK::HOODI'd rather be at the PenobscotThu Sep 01 1994 11:185
Did the installation of HUBwatch give any errors?  Did it correctly determine
that you were running UCX?

Tom Hood
HUBwatch
1367.2can you Ping it?MINNY::SCHUMACHERMore than cows & chocolate...Thu Sep 01 1994 14:1910
    And, can your system running Hubwatch see your agent in terms of
    TCP/IP. I got the same error once on my VAXstation if I had no route
    to my agent. So make sure you can ping your agent.
    
    UCX> PING <your agent's ip address>
    UCX> SHOW ROUTE
    and if needed:
    UCX> SET ROUTE <agent network> /GATE=<your gateway ip addr> /PERM
    
    Cheers, Peter