| Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
| Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
| Moderator: | NETCAD::COLELLA DT |
| Created: | Wed Nov 13 1991 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4455 |
| Total number of notes: | 16761 |
I have been trying to configure HUBwatch for Windows on following
environment.
486 PC with 3COM 3C523
ODI DRIVER (or NDIS)
Windows for Workgroups V3.1
HUBwatch for windows V2.0
When enter IP address on HUBWatch window, but HUBwatch not work
with following error message.
The socket cannot be created.
Error Number returned : 1001.
No TCP errors on boot and can ping to other node.
I got following error message when windows up,
VTCPIP : Device load failure
TCPIP is not install or not right version.
I try to change the TCPIP module from Pathworks's to novel's.
no error message on windows up.
But HUBwatch still not work same message.
My Question is,
Does HUBwatch for windows support on Windows for Workgroups?
Any Workaronud to fix this problem ?
Thanks in advance,
Atsushi Shiozawa
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 1026.1 | QUIVER::MESSINGER | Wed May 25 1994 11:54 | 5 | ||
Workgroups was not supported in this release. We'll add it to the
list.
Fred
| |||||
| 1026.2 | reason? | TKTVFS::SHIOZAWA | Atsushi Shiozawa@TKT /Japan/MCS/tokyo system service 2 | Wed May 25 1994 23:01 | 20 |
> Workgroups was not supported in this release.
I want to know this reason.
Many applications running on Windows are also running on WFW.
Any difference on Window socket calling between Windows and WFW?
Or any other reason for not support?
Are there any workaround on WFW?
I want to try to configure on WFW, but I'm not familiar to PC and
PC applications.
> We'll add it to the list.
When will be supported on WFW ?
Next version? (V3.0?)
Please give me any additional information.
Thanks,
Atsushi
| |||||
| 1026.3 | one solution | QUIVER::ORSHAW | Thu May 26 1994 14:15 | 6 | |
We didn't support it because Pathworks didn't support it in their v5.0
stack. I believe you can now get a version of Pathworks that works with
WFW. If this is true, use the new Pathworks stack and Hubwatch should
run just fine. (I have not done this myself so I could be wrong).
Jim
| |||||