Conference netcad::hub_mgnt

492.0. "DecBrouterT1 With Hubwatch" by PADNOM::PEYRACHE (Sarip Torppus Lanoiger) Fri Nov 12 1993 06:33

  hi,

  Seems to be some problems to add/manage a DECbrouter90 T1 on Hubwatch v2.0-1

  in deep:


  Hubwatch for OpenVms v2.0-1 Decagent x2.0

  when i add a Decbrouter T1 on Hubwatch using Configuration Item,Add Module,
  choice a Decbrouter90T1,enter Mac address,Ip Address,Community,etc after that
  apply my choice:

  2 stranges things appears:

  one on Huwatch Display of my Hub90 a DecBrouter90T2 (yes T2 with 2 synchronous
  lines) appears on the screen,of course if you select this module all          
  characterics are for Decbrouter90T2 (line ...etc).

  Secondly ,in fact result of mismatch, on the Window message of my Vaxstation
  string of message appears during insertion of Decrouter90T1:

>>(I) Slot 2:  DBRUT1  module INSERTED
>>(I) Slot 2: Port 1:  status = ONLINE
>>(I) Slot 2: Port 2:  status = DISCONNECTED (OFF) !!!! whaou where is this port
>>(I) Slot 2: Port 3:  status = ONLINE             !!!!  on Decbrouter90T1 


  thanks for any comments/inputs

  Regards

  Jean-Yves

  

>  when i add a Decbrouter T1 on Hubwatch using Configuration Item,Add Module,
> [...]
>  one on Huwatch Display of my Hub90 a DecBrouter90T2 (yes T2 with 2
    synchronous


It's a feature.  Buy HUBwatch, get a free sync port.  8-)

Sigh, I'll take a look at it.

Tom H

   hi,

 any news about this problem , have reproduced it in your lab ??

 thanks for any replies


  Jean-Yves