[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

310.0. "DENMA needs FACTORY RESET after upgrade to V1.1" by LEVERS::BENSON (DTN 227-3555) Wed Jul 21 1993 17:53

    Due to a bug recently found in the DENMA V1.1 code it is necessary to
    perform a FACTORY RESET after upgrading to V1.1 from a previous
    version.

    The problems may only surface when a bridge is present in the AGENT's
    HUB.  One failure mode causes the repeaters in the AGENT's community to
    not be manageable.  If the bridge in the AGENT's community is queried
    via mop console for the status of the repeaters, it replies that 'the
    bridge is not the hub manager'.  Another possible failure mode is that
    the AGENT exports the bridge out of the AGENT's community.  

    It is necessary to FACTORY RESET all DENMAs regardless of configuration
    to prevent this problem from resurfacing after some later
    reconfiguration of the HUB.
T.RTitleUserPersonal
Name		DateLines