| If you have the A2090, it's in the manual (but you have the find
it!) Ok -- you need two cables 20 and 30 pins I think. Both will
have one different colored wire on one edge. Connect the narrow
cable to the connector labeled J1 on the 2090 controller with the
colored wire facing the rear of the machine. Plug the wide connector
with the colored wire facing the same way. On the Drive, plug each
cable onto its respective plug with the colored wire toward the
power connector. Finally, connect power from one of the female 4-pin
D connectors sticking out of the power supply on those colored wires
-- there's one small one for a second 3.5" floppy, that's not the
one; the other two are much larger.
<the end>
|