| Hello,
I have run this Demo on a DECstation 5000/200. It works nicely.
You can get the Executables loaded if you call your local ChipCOM sales
representative. I watched him load the code, and he carefully took
his source code with him. You can get yours the same way.
It is launchable from PolyCenter 300. I haven't tried a launch
from Poly200 under Ultrix. I used a command-line prompt startup, with
the ip address as an arguement, and it worked nicely.
The Graphics are -OK-, but a little tiny, and hard to read. The
appearance is NOT MOTIF, and sort of "unfinished looking" in my
opinion. But the functionality is good. I didn't have enought memory
on my DECstation 5000/200 to run both HubWatch, PolyCenter 300, and NCS
at the same time. It crashed whenever I ran them all, even when one
was reduced to an Icon. So I only ran two at a time. Any two would
function well together. I had 32 Meg. I would suggest far more.
JR
|