| Title: | DECmcc user notes file. Does not replace IPMT. |
| Notice: | Use IPMT for problems. Newsletter location in note 6187 |
| Moderator: | TAEC::BEROUD |
| Created: | Mon Aug 21 1989 |
| Last Modified: | Wed Jun 04 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 6497 |
| Total number of notes: | 27359 |
Hello, We see in line statistics of a x25 line a lot of "CoCOUNT OF REMOTE REPLY TIMEOUTS". If we do a show counter at the begin and the end of the statistic scope of interest time, We see not so much errors. Example: >>> show node4 ... line x25-o all count Counter from 19:00:00 Remote Reply Timeout = 10 Counter from 19:30:00 Remote Reply Timeout = 15 >>> show node4 ... line x25-o all statistics Counter from 19:30:00 Count of Remote Reply Timeouts = 251 Error Percent = 44.27 We see this very often. It seems, that statistic counts not the difference from begin to the end of the scope of interest, it counts 256-difference. We run alarms on error statistics, this are fired lot to much. Is this a known bug? Roland
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 3692.1 | ZUR01::SCHNEIDERR | Tue Sep 08 1992 03:57 | 12 | ||
Hello, I found in the Release notes on page 2-15 under restrictions for the Phase IV AM: "There is no X25 module support in the Decnet Phase VIV Access Module" Does this mean that no X25 at all is supported (so no X25 lines and no X25 DLM circuits) or does it mean that only X25 SW modules (module X25-protocoll, X25-access, X25-server) is not supported? Roland | |||||
| 3692.2 | dlm supported | BONNET::MALAISE | All you need is laugh! | Fri Sep 11 1992 18:51 | 20 |
<<< Note 3692.1 by ZUR01::SCHNEIDERR >>> > >Hello, > >I found in the Release notes on page 2-15 under restrictions for the Phase IV AM: > >"There is no X25 module support in the Decnet Phase VIV Access Module" > >Does this mean that no X25 at all is supported (so no X25 lines and no X25 DLM >circuits) or does it mean that only X25 SW modules (module X25-protocoll, >X25-access, X25-server) is not supported? Only X25 software => you need to use NCP set mod x25-dte .... DLM are supported . Regards . MaRc > >Roland | |||||