| T.R | Title | User | Personal
Name | Date | Lines |
|---|
| 3021.1 | More info please | QUIVER::HAROKOPUS | | Tue May 19 1992 10:56 | 14 |
| Hi Roland,
Can you do the following commands on the bridge in question and post
the results here.
Thanks,
Bob
mcc>show bridge <bridge_name> firmware version
mcc>show bridge <bridge_name> software version
mcc>show mcc 0 bridge_am all char
mcc>show mcc 0 pa all char
|
| 3021.2 | YOUR INFOS | ZUR01::SCHNEIDERR | | Fri May 22 1992 07:02 | 24 |
| Hello,
Here the output you asked for:
MCC> show bridge firmware version --> Firmware Version = V2.9.0
MCC> show bridge siftware version --> SOFTWARE VERSION = V1.1.0
MCC> show mcc 0 bridge_am all char
Component Identification = "DECmcc Bridge AM"
Component Version = V1.2.0
MCC> show mcc 0 pa all char
Component Version = V1.1.0
Component Identification = "DECmcc PA FM"
I hope this helps you. Just to compleate all infos. We often have problems to
access the bridges. Then we get the message "Communication with target has been
interrupted". But I think this has nothing to do with the percent statistic
problem.
Regards Roland
|
| 3021.3 | | SLINK::CHILDS | Strike a poseur. | Thu May 28 1992 11:28 | 18 |
| | We often have problems to
| access the bridges. Then we get the message "Communication with target has
| been interrupted". But I think this has nothing to do with the percent
| statistic problem.
The message you are getting is a timeout. Does your network have
unusually high traffic?
The statistic numbers you are getting need to be fixed. Someone from
the PA team should post the formulas that are used to calculate
Multicast Utilization and Network Utilization and we can see what
numbers the bridge is providing.
I also noticed a spelling error in the latest PA code I'm running:
Multicast Throuhghput = 98.91 Percent
This should be fixed for SSB.
|
| 3021.4 | request for more info... | QUIVER::HAROKOPUS | | Fri May 29 1992 14:21 | 12 |
| Hi Roland,
It looks like you are at the right firmware level. Could you please post
the following so I can investigate further:
mcc>show bridge <bridge_name> line 2 all counters
mcc>show bridge <bridge_name> line 2 all statistics
Thanks,
Bob
|
| 3021.5 | Here your counters | ZUR01::SCHNEIDERR | | Tue Jun 09 1992 05:09 | 85 |
| Hi Bob,
Here your requested datas:
BRIDGE MCCEMS_NS:.Basel.IS.bridge.K621 LINE 2
AT 2-JUN-1992 15:24:44 Counters
Examination of attributes shows:
Counter Creation Time = 28-MAR-1992 01:52:20.60
Port Restarts = 0
Total Frames Received = 14802612 Frames
Total Bytes Received = 970722729 Bytes
Device Frames Received = 0 Frames
Device Bytes Received = 0 Bytes
Multicast Frames Received = 595362 Frames
Multicast Bytes Received = 48925870 Bytes
Total Frames Sent = 1098402134 Frames
Total Bytes Sent = 26671792398097 Bytes
Device Frames Sent = 5902976 Frames
Device Bytes Sent = 405355520 Bytes
Multicast Frames Sent = 1077188465 Frames
Multicast Bytes Sent = 26670188655009 Bytes
Bad Frames Received = 0 Frames
Transmit Frames Lost = 0 Frames
Lifetime Exceeded Frames = 0 Frames
Receive Frames Lost = 0 Frames
Frames Filtered = 0 Frames
Bytes Filtered = 0 Bytes
Receive Overruns = 0 Frames
Forwarding State Entered = 1
Invalid Device Messages = 0 Frames
Bad Hellos Limit Exceeded = 0
Multicast Frames Filtered = 0 Frames
Multicast Device Frames Received = 0 Frames
Multicast Device Frames Sent = 5902976 Frames
Device Frames Lost = 0 Frames
Transmit Error Frames = 5 Frames
Bad Bytes Received = 0 Bytes
Multicast Source Frames Received = 0 Frames
Transmit Error Bytes = 327184 Bytes
Invalid Device Bytes = 0 Bytes
Multicast Device Bytes Received = 0 Bytes
Multicast Device Bytes Sent = 405355520 Bytes
Oversize Frames = 0 Frames
Framing Errors = 0
Transmit Multiple Collisions = 37865
Carrier Lost = 5
Collision Limit Exceeded = 0
Unknown Destination Addresses Received = 0
Frames Addressed Filtered = 0 Frames
Frames Protocol Filtered = 0 Frames
Bytes Addressed Filtered = 0 Bytes
Bytes Protocol Filtered = 0 Bytes
Collision Presence Test Failed = 175
Length Error = 1
BRIDGE MCCEMS_NS:.Basel.IS.bridge.K621 LINE 2
AT 2-JUN-1992 15:29:46 Statistics
Examination of attributes shows:
Duration = 300 Seconds
Count of Total Frames Sent = 78376
Count of Total Frames Received = 649
Originating Bridge Frames = 0.4 Percent
Terminating Bridge Frames = 0 Percent
Filtered Frames = 0 Percent
Network Utilization = 379.72 Percent
Multicast Utilization = 379.69 Percent
Single Destination Utilization = 3.000000E-02 Percent
Single Destination Throughput = 2.2 Percent
Multicast Throuhghput = 97.8 Percent
Bad Frames = 0 Percent
Frames Discarded Lifetime Exceeded = 0 Percent
Frames Received with Unknown Destination Addresses = 0 Percent
Inbound Frames Lost = 0 Percent
Outbound Frames Lost = 0 Percent
Count of Invalid Protocol Messages = 0
Error Percent = 0 Percent
This is just from one bridge. For a compleate show output you can have a look to
NAPPY::MCC_SHOW_BRIDGE.TXT (NAPPY = 48.523)
Regards Roland
|
| 3021.6 | | ZUR01::SCHNEIDERR | | Fri Jun 19 1992 05:02 | 5 |
|
I posted in Re. -1 requested infos. Is this what you need? I need some answers
Thanks and regards Roland
|
| 3021.7 | | QUIVER::HAROKOPUS | | Mon Jun 22 1992 12:49 | 12 |
| Hi Roland,
From the data you posted it looks like the problem is in the PA FM as
opposed to the Bridge AM or bridge firmware. The good news is that
this seems to work fine on the DB 610 in V1.2.
If you can't wait for V1.2 then talk to Anwar (TOOK::ANWARUDDIN).
He is the project leader for the PA FM.
Regards,
Bob
|
| 3021.8 | will wait to 1.2 | ZUR01::SCHNEIDERR | | Tue Jun 23 1992 10:24 | 6 |
| Bob
We will wait to 1.2 ans then see whats happen.
Thanks and regards Roland
|
| 3021.9 | as an aside | TOOK::CALLANDER | MCC = My Constant Companion | Fri Jul 24 1992 13:57 | 4 |
| Anwar has retired, please send PA questions to either Anne (took::) Pelagatti,
Bob (took::) Merrifield or myself.
thanks
|