Conference azur::mcc

2527.0. "ULTRIX ELM installation problems" by JGO::PAIJMANS () Wed Mar 11 1992 07:20

	Recently I installed the 1.2.4 Ultrix version.
	I have some problems starting this up correctly.

	During the installation of the base system I do get the following
	error (According to the release notes, it can be savely ignored,
	page 3-4)

	in the Domain FM:
	internal error: cma__open_general: unexpected fstat error
	mcc_enet_am thread exeption, internal error detected in thread 
	library.

	But until this point things work fine.
	I was able to retrieve the Objects and MAPS from our
	previous VMS MCC 1.1 version (excluding bridges, terminal
	server and vitalink info). 

	Afterwards I installed the ELM module. Installation went
	fine (it took approx 1.5 hour on my DECstation 3100).
	I see the following problem when I want to open a domain in the
	iconic map.
	When I tried to filter domains I get the following message:
	MCC pop-up window: Error in full name value (default *,
			   which worked before produces this message now)
	The second time I start up MCC and issue a filter command
	I see the following messages:
	MCC pop-up window: target management module thread has aborted
	DECTERM message: Exeption in mgt module (id=7), CMA code = 40802c
	If I do not leave mcc and issue the filter a second time it seems
	to hang.

	I deleted all MCC savesets and started all over again.
	As soon as the access module is installed, then things
	do not work properly in the iconic map.

	If however I start up the FCL interface or issue the command
	manage, I am able to list all domains by using the command:
	SHOW DOMAIN * ALL IDENT.

	My configuration:
	DECSTATION 3100.
	Ultrix 4.2A
	DECnet/OSI 5.1.1
	DECMCC T1.2.4
	ELM 1.2.0
	DNS on node nmgmcc contains our MCC database.

	Could it be I am missing an ULTRIX subset. the two mentioned in
	the release notes are installed. UDTINET420
					 UDTINTLRT420

	Did someone else experience this behavior?
	A colleque installed the same ELM saveset on his
	ultrix station and this works fine (he is using a local MIR
	though and installed ALL ultrix savesets.).

	It is a very consequent and consistent error.
	Could anyone give me a hint where to look for?

	regards,
			Edward.

I have entered this as a QAR against system, since the symptoms seem
general (although triggered by the ELM installation).

>	in the Domain FM:
>	internal error: cma__open_general: unexpected fstat error
>	mcc_enet_am thread exeption, internal error detected in thread 
>	library.

Yes, this is of no consequence, and you can ignore it.

>	Could it be I am missing an ULTRIX subset. the two mentioned in
>	the release notes are installed. UDTINET420
>					 UDTINTLRT420

Unless the ELM installation requires something special,
this problem is unlikely to be caused by missing subsets.
However, someone may contact you for the full output of "setld -i"
on your system.

See note 2345.5 and .9-.12.  Go back to the IMPM from the DECmcc kit, instead of using the IMPM from the ELMS kit.

Eric - thanks for entering the QAR.  I thought someone was already looking at his problem.

	- Andy

	Thanks it works again with the 'old' mcc_iconic_map_pm file

	Regards,
			Edward.