| Title: | DECmcc user notes file. Does not replace IPMT. |
| Notice: | Use IPMT for problems. Newsletter location in note 6187 |
| Moderator: | TAEC::BEROUD |
| Created: | Mon Aug 21 1989 |
| Last Modified: | Wed Jun 04 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 6497 |
| Total number of notes: | 27359 |
Installing Ethernet AM from the 1.1 kit.
It does not allow the registration of ethernet devices. The MCC has
Phase IV nodes up and being monitored, but every time an ethernet
address is registered it responds with "cannot communicate with
target".
This has none of the point products installed, so I do not believe
there would be an issue with contention for the ethernet port. I was
also specifiying the port ESA0: when registering. (ie via port eas0:).
I am sure it is something basic, but I was unfortunately working blind!
Any help would be appreciated.
Regards,
Rex
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 1002.1 | Need more detail... | CHRISB::BRIENEN | DECmcc Bridge|Station|SNMP Management. | Tue May 14 1991 10:27 | 14 |
You haven't supplied enough information for me to help you. What "ethernet devices" are you trying to register? Can you supply a sample of the REGISTER syntax you are using? If you're trying to REGISTER stations that are part of a Phase IV node, are you apecifying both the DECnet Physical Address and the Hardware Address? Are you specifying just the ROM Address? Can you post the output of the SHOW MCC 0 ETHERNET_AM ALL STATUS command? Why are you using VIA PORT? | |||||