| Title: | *OLD* ALL-IN-1 (tm) Support Conference |
| Notice: | Closed - See Note 4331.l to move to IOSG::ALL-IN-1 |
| Moderator: | IOSG::PYE |
| Created: | Thu Jan 30 1992 |
| Last Modified: | Tue Jan 23 1996 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4343 |
| Total number of notes: | 18308 |
I have been seeting up a new system with:
VMS 5.5
MR 3.2
Notes 2.2
FMS 2.4
When I go to install ALL-IN-1 3.0 from the CD-rom issued in May/92 I
get this strange error.
The installation proceeds fine and creates all of the directory
structure. The starts to restore the remaining LANGUAGE kit
save sets
The installtion restores save set C,D,E,F and then
I get the following
%DCL-W-IVVERB, unrecognized command verb - check validity and spelling
\FMS\
the installtion then fails
Am I using the wrong save sets or kits?
Any further infor that I can supply?
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 945.1 | FMS not installed | AIMTEC::WICKS_A | DEC Mail Works for ME sometimes | Fri Jun 26 1992 18:04 | 34 |
FMS is not installed correctly see the STARS article below
V3.0 Installation: Access Violation When Restoring Product Saveset F
COPYRIGHT (c) 1991, 1992 by Digital Equipment Corporation.
ALL RIGHTS RESERVED. No distribution except as provided under contract.
PRODUCT: ALL-IN-1 IOS 3.0
SOURCE: Customer Support Center / USA
PROBLEM:
During the installation of ALL-IN-1 V3.0, an access violation
occurs when restoring Product Saveset F. Error message :
"OP Code Reserved By Digital."
ANALYSIS:
Saveset F contains the ALL-IN-1 form libraries.
From DCL attempt to use a valid FMS command is unsuccessful.
CAUSE:
FMS not installed properly on the system.
SOLUTION:
Re-install FMS from the ALL-IN-1 V3.0 kit. Once completed successfully
then attempt the ALL-IN-1 V3.0 installation again.
| |||||
| 945.2 | Or Problem with DCLTABLES ... | VNABRW::EHRLICH_K | Karl 'Charly' Ehrlich | Mon Jun 29 1992 14:03 | 16 |
Hi,
or maybe you have two versions of DCLTABLES, one in SYS$COMMON:[SYSLIB]
which should be the right one, and one in SYS$SPECIFIC:[SYSLIB].
I've ran into the some problem after many installations before
ALL-IN-1 V2.4.
During the restore of the saveset the same errormessage returned to me
and I saw that FMS command was set into the wrong DCLTABLES.EXE.
Hope this helps
Regards,
Charly_from_Vienna
| |||||
| 945.3 | DCLTABLES problems. | IOSG::BURTON | ALL-IN-1 Builder | Tue Jun 30 1992 07:48 | 6 |
It could be the new version of DCLTABLES hasn't been installed on all
nodes of the cluster, or you haven't logged in again so your process is
still using the old version.
Martin.
| |||||