| Title: | Alpha Workstation Conference |
| Notice: | See note 1.* for conference notices |
| Moderator: | WRKSYS::HOUSE |
| Created: | Wed Sep 07 1994 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 1996 |
| Total number of notes: | 9122 |
I have an as255 and reloaded arc from firmware cd-v3.8
Upgrade went ok, but when powering up the system it is coming
up with press F2 for setup. When pressing F2 it reinit and than
again press F2 to enter setup.
This machine run unix before without problems.
Replaced motherboard and new board come up with three chevrons.
Set os_type NT and update arc again. Ended up with same problem.
Are we doing something wrong or is there a problem with 3.8 CD?
Tried to reset flash using sw 1,2 but no luck.
Every new idea is welcome
Ben
Palo Alto CA
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 1830.1 | See 1801.*? | OSLLAV::JENSH | Jens Holwech, SI Technology Group, Norway (DTN 872-8543) | Mon Feb 03 1997 02:11 | 4 |
Same trouble as in 1801.*? Regards, Jens | |||||
| 1830.2 | fixed | CALDEC::BOSKLOPPER | Mon Feb 03 1997 12:12 | 9 | |
Problem is fixed. We worked over the weekend and this was a unix
system with a vt420 console. When updating from srm to arc it looks
the console mode is graphics now. We used cntrlB for setup with the
vt420, but never get it working. We connected a vga screen and it
works fine right the first time. This is not in the user guide or
release notes so if you changed firmware be sure you use a vga screen.
Ben
Palo Alto CA
| |||||