|
re. .0
I use something similar to your method for just about any venison
I cook (the exception is backstrap). As a rule, I will soak
venison in salt water, milk or vinegar for about thirty minutes
before I cook it. It draws the blood and takes out a lot of
that wild flavor. I know that some people like the wild flavor,
but I don't. I do, however, like venison prepared this way.
By the way, it is my experience that this is not necessary with
elk. My theory is that an elk's diet is much closer to a cow's
diet, and thus tastes more like beef.
Jerry
|
| I've been doing my own butchering for about 12 years now. The
first and last time I took an elk in to a shop, they did a poor
job, kept alot of the good cuts or cut them wrong, and charged
me big bucks. So my hunting partners and I started doing it
ourselfs. First couple of times butchering took forever. Kept
getting in each others way, cutting fingers, etc. Then we got
organized. This is how we do it now:
Cool down procedure:
Turn my garage into a cooler, take off back door and install a
sheet of plywood with two air conditioners in door opening.
Hang game to cool for 4-5 days.
Do pre butchering trim, hair removal, jelly membrane removal.
Note: Only remove minimal outer membrane, as it keeps meat from
drying out.
Setup procedure:
Move in picnic table and two large kitchen counter tops to cut on.
Get as many large deep pans or plastic tubs we can find in house.
6 very sharp butcher knives and stones.
Large supply of freezer paper, tape, and markers.
A couple of large trash cans for scrapes.
Lots of lights, need to be able to see those hairs.
Music to rock and roll by.
Butcher procedure:
Everyone is assigned a task.
We start with the front shoulders. One guy removes them and two
will trim remaining membrane, fat, etc.
One will then debone the meat, selecting sections for roast or stew
meat, with the rest going in the burger pan.
The roast and stew pieces go in a seperate pan, which my wife will
select the amount to be packaged for meals, and wrap them.
Next we remove the two backstraps, my favorite parts, and cut them
1" to 1 1/2" thick. Wife again wraps them.
The ribs are then cut apart and sized. This is optional, they can
be deboned for burger. We don't even mess with deer and antelope
ribs.
The rest of the meat from the neck to front of rear quarters is
trimed off for burger.
Tinderloins are removed and soaked in saltwater over night along
with any meat that is bloodsoaked and saveable.
The rear quarters are sawed apart, membrane and fat removed.
Then the major sections of the rear quarters are removed in pieces
rather than having a steak 24" dia.
Those sections are then cut to thickness and wrapped.
The top of the leg is deboned and cut to steaks or roast and the rest
goes to stew or burger.
The lower legs get the membrane and tendons removed and ground up.
While all the deboneing and cutting is going on, someone is grinding
burger. It gets mixed with 25% GOOD beef fat and ground twice.
Now its party time.
Notes:
If not familiar with the cuts, get a chart cut chart from local
butcher shop or meat dept in store.
Keep knives very sharp.
Always cut steaks across the grain.
|
|
We hunt on a little old lady's farm property, and the suggestion she has is
to mix a little vinegar with some water to pull the "gamey" taste out of
the meat. How much is a little? I'll find out in about a month when I see
her, but I would think maybe 1 cup added to a gallon of water...
Scott
|