| > Do I have any problems when in a GS/FDDI Boards have a different FW
> Versions?
It depends on the firmware versions.
> In a GS/FFDI of a Customer there are 2 SCO's. One has a V.2.0 and one
> hase V3.01. The SCP with V3.01 is the elected SCP the other is in Bakup
> state.
> There are also 4 FGL2 LC. 3 have V.2.2 and one has 3.01
...this is a problem.
> When using HUBwatch and selecting the Boards with the highest Version
> everything is ok. But when selecting a Board with V.2.X HUBwatch say's
> Version miss match.
> The Switch seems to work properly but my Customer is a bit concerned
> about that.
...as they should be - as detailed in the release notes, the BL3.0
firmware and later requires that the FGLs be upgraded to BL3.0. Mixing
firmware versions is seldom a good idea.
> It is a highly produktive site (Bank) so it is not possible to upgrade
> the GS/FDDI soon.
In this case, it is an unsupported configuration.
MDL
P.S. GIGAswitch/FDDI issues are normally addressed in the
SCHOOL::GIGASWITCH notes conference
|