| Title: | FDDI - The Next Generation |
| Moderator: | NETCAD::STEFANI |
| Created: | Thu Apr 27 1989 |
| Last Modified: | Thu Jun 05 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 2259 |
| Total number of notes: | 8590 |
Also posted in Cisco notes conference. -------------------------------------- We get the following error message when we connect a Cisco 7000 to an existing FDDI ring consisting of DECconecentrator 500s and DECbridge 600s. %cbus-3-init error interface 8 error (802E) LDB0000000 0 RX_SETUP -CBUS-INIT When we put a FDDI cable on the 7000 from port A to port B there were no errors. As per Cisco systems error messages, this means a H/W device did not respond appropriatley to a request and the Recommended Action is "Make sure the device is functioning and is configured correctly." We replaced the FDDI card in slot 8 - still same problem. We replaced Switch processor and had a different problem. Unable to boot up using the new switch processor module. This board fails with exception l4 at pc 0x120c. I am trying to get all the rev level information. Any suggestions ? Alphonse
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 1613.1 | Cisco 700 with DECbridge 900MX is OK but not with DECbridge 620 | GIDDAY::STANISLAUS | Wed Mar 08 1995 19:54 | 6 | |
When we connect the Cisco 7000's FDDI card to a ring with DECbridge 900MX it works OK. When we connect it to a DECbridge 620 it fails with the symptom in .0. Alphonse | |||||
| 1613.2 | NPSS::RAUHALA | Thu Mar 09 1995 17:15 | 5 | ||
What version of DECbridge 620 code are you using??
Is the fddi ring operational at all or is the ring dead??
ken
| |||||