Conference 7.286::fddi

318.0. "UPDATING FLASH MEMORY" by PEACHS::SCHULTZ (Peripheral Visionary...) Thu Aug 01 1991 16:32

    
    I am updating 3 Concentrators that were running 2.2 code and get some
    informational messages about "Insufficient NCP log"
    
    Here is an excerpt of the update prodedure with NDU
    
    $ download load/log/confirm 08-00-2b-1b-d1-f0 mom$load:defcn023.sys
    %NDU-I-SEND_ELMS_RDDEV, Sending RBMS read device message
    %NDU-I-TARGET_VERSION, Target device is a DEFCN version 2.3
    Do you wish to continue? (y/n) y
    %NDU-I-SET_DLU_TRUE, Setting RBMS DLU switch to TRUE
    %NDU-I-SPWNNCP_CIR, spawning NCP subprocess to show circuits
    %NDU-I-NCP_SRV_ENA, NCP circuit service enabled
    %NDU-I-CIR_ENABLED, Circuit service enabled.  Must be disabled.
    Do you wish to continue? (y/n) y
    %NDU-I-NCP_SET_STATE, setting circuit service state
    %NDU-E-INS_NCP_LOG, insufficient NCP log
    %NDU-I-START_DLU, Beginning MOP downline load
    %NDU-I-WAIT_BOX, Waiting for box to come back on-line
    %NDU-I-SEND_ELMS_RDDEV, Sending RBMS read device message
    %NDU-I-DEV_BACK, Device back on line
    %NDU-I-TARGET_VERSION, Target device is a DEFCN version 2.3
    %NDU-I-SET_DLU_FALSE, Setting RBMS DLU switch to FALSE
    %NDU-I-NCP_SET_STATE, setting circuit service state
    %NDU-E-INS_NCP_LOG, insufficient NCP log
    $
    
    This reports that the DEFCN is already at 2.3, but this was the second
    run so that I could capture the message. The DEFCN came back online and
    seems to be operating properly. I was just curious about the message...
    
    MTS