[Search for users]
[Overall Top Noters]
[List of all Conferences]
[Download this site]
| Title: | Server_works |
|
| Moderator: | PCBUOA::IS_SYSTEM |
|
| Created: | Fri Jun 30 1995 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 291 |
| Total number of notes: | 1063 |
Hi,
I have used ManageWorks v2.2 and MultiChassis Manager v5.0.
Then I upgraded MCM to 6.0A because of new VN switch in network.
After that, if I try to start MCM from MW I get following message:
Could not load CustCntl.dll please exit this program.
The Hub front screen comes up but if I click on a module I get the
error that this application has performed an illegal operation and to
shut it down now. Then the hub goes away.
There is the same question in hub_mgnt on netcad,
Topic #4389: ``Problems running Cvision MCM after Manageworks??''
from which is part of this question copied, but no answer.
Can anyone help?
Jiri, MCS Prague
[Posted by WWW Notes gateway]
| T.R | Title | User | Personal
Name | Date | Lines |
|---|
| 275.1 | Re-Integrate? | PCBUOA::WHITEC | Parrot_Trooper | Fri May 16 1997 09:28 | 10 |
| Did you re-integrate the MCM application into manageworks after
installing 6.0? Manageworks may think it's still talking
to the old one?
Don't know anytyhing about MCM but this could be the problem,
especially if the CustCntl.dll was deleted/modified when the
upgrade happened.
Chet
|
| 275.2 | | NNTPD::"[email protected]" | zelenka | Mon May 19 1997 03:21 | 7 |
| Hi,
thank you for answer.
I made a fresh installation (1. W95-MW-MCM, 2. W95-MCM-MW)but it didn't help.
Jiri
[Posted by WWW Notes gateway]
|