| Title: | atm |
| Moderator: | NPSS::WATERS |
| Created: | Mon Oct 05 1992 |
| Last Modified: | Thu Jun 05 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 970 |
| Total number of notes: | 3630 |
Hello
We are getting the message "sorry ,this system is engaged" when connecting
via telnet to the ATMswitch900F.
There was a previous working telnet connection, but this connection failed and
was abnormally terminated by a reboot from the VNswitch where the telnet PC was
connected to.
ATMswitch is still using the old connection while a new connection can't be
made.
Is there a workaround to release the telnet port on a ATMswitch900F
after an abnormally broken connection.
The only solution I found was reboot the ATMswitch 900F.
Access to the ethernet port of the ATMswitch900F is via the thinwire in the
HUB900
Implementation of an idle timer on the console would be a good solution.
I had a similar behavior on the telnet session to the GIGAswitch ATM.
Regards Gerrit
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 937.1 | <Could ObmClear do the trick ? | UTRTSC::DENIJS | Mon May 12 1997 06:46 | 8 | |
Hoi Gerrit,
The GIGAswitch/ATM has a console command to clear a flag that the
telnet session is used. I think the command is obmClear.
Do help in the GIGAswitch/atm prompt and it will tell you.
I dont know if the ATMswitch900 has the same command.
Regards, Peter.
| |||||
| 937.2 | Do "logout" befor quiting. | NNTPD::"eric gan@bej" | ericgan | Sat May 31 1997 01:22 | 4 |
Just do "logout" to disconnect telnet session every time. eric [Posted by WWW Notes gateway] | |||||