T.R | Title | User | Personal Name | Date | Lines |
---|
2208.1 | Brute force but not to much ignorance is required! | WELCLU::YOUNG | Policemen aren't nasty people | Wed Jan 19 1994 23:03 | 29 |
|
Sounds as if you were told right, what is required is a sudden jolt to
free the friction plate from the flywheel, try turning over on the
starter while in gear with the clutch pedal depressed (and the wheels
well chocked) however if it doesn't free in a couple of short sharp
attempts give up on this route or you will nacker the starter/ring
gear.
Alternatively you could try pushing/towing with it in gear (1st)and the
clutch depressed.
Does your car have an inspection plate on the bottom of the bellhousing
you could try a couple of taps on the clutch assy through the
inspection hole or remove the starter and go through that hole (again
with clutch depressed)
Or you could put the car in gear, get someone to depress the clutch
pedal and try turning the engine over by hand with a socket on the end
of the crank-shaft.
Basically you need to force the flywheel and the clutch friction plate
to separate, all the above (apart from the tap with the hammer) are
attempts at this.
Failing all these it's time for the gearbox to come out! 8*)
Good luck keep us posted!
Richard
|
2208.2 | Maybe I should just walk.... | KIRKTN::DALEXANDER | My hovercraft is full of eels | Thu Jan 20 1994 05:46 | 7 |
| >>failing that it's time for the gearbox to come out.8*)
With the luck I have with cars that is just what will have to
happen.8*((
Dougie.
|
2208.3 | Been there, done that... | VANGA::KERRELL | The first word in DECUS is Digital | Thu Jan 20 1994 08:02 | 4 |
| Taking the gearbox off a Ford Capri is sooo easy. You can change the whole
clutch in about 30 minutes with a socket set, an alignment tool and some ramps.
Dave.
|
2208.4 | | YUPPY::BUSH | Alive and Kicking | Thu Jan 20 1994 10:45 | 5 |
|
Push the clutch down with a broom handle, wedge aforementioned
broom handle in this position and leave overnight!!!!
I read this in, I think, Performance Car. It actually worked as well!!
|
2208.5 | | SBPUS4::Mark | | Thu Jan 20 1994 10:53 | 4 |
| Put the car in 2nd gear, pref. on a road or long drive, with the handbrake
off. Turn the starter motor until it starts (it will lurch forward whilst
it's trying to do this. You may want to have already run the engine to make
sure it will start easily). The kick as it fires will free it.
|
2208.6 | Get it warm first. | ROCKS::CAMP | | Thu Jan 20 1994 11:19 | 7 |
| As .5 mentioned but before you do it let the engine get up to working
temperature that way it will fire and run more easily.
Re: Tow starting a car. Its not a good idea to attempt to start it
1st, far better to use 3rd or 4th as its a lot less strain on the
transmission, tyres and nerves, but you need to be quick with the
clutch.
|
2208.7 | | CGOOA::PITULEY | Ain't technology wonderful? | Thu Jan 20 1994 15:54 | 6 |
|
Could it be something as simple as a hydraulic clutch that's out of
fluid??
Brian
|
2208.8 | probably not.... | WOTVAX::STONEG | Temperature Drop in Downtime Winterland.... | Thu Jan 20 1994 16:23 | 6 |
|
...Not on a 2.8 Capri......
assuming, of course it's the same car... %^)
G
|
2208.9 | give it a bang | KERNEL::BARTHUR | | Fri Jan 21 1994 09:55 | 18 |
|
Had exactly the same with the old Jag and i nearly gave up, it took
ages to free it. Here's how.
Start the car and let it get really warm, ie; ticking over for an hour.
Switch off and leave for twenty, so the heat gets into the ring gear.
Put the car in top, handbrake on tight and "jolt" the starter while
pumping the clutch pedal. Eventually it will come off and when you slip
the clutch you'll probably hear the rust being cleaned off the
flywheel.
Alernatively, tie the bottoms of your trousers round your legs, find a
straight clear piece of road, into gear handbrake off and bounce the
car forward on the starter. Entertaining and quite effective.
Bill
|
2208.10 | More of same. | CMOTEC::JASPER | Stuck on the Flypaper of Life | Mon Jan 24 1994 10:41 | 9 |
|
... I started my car in 1st gear (on an empty road :^)) then depressed
the clutch to the floor & held it there. Next I continually Kangarood
the car by stamping on the accelerator then letting the pedal fly up by
slipping my foot off it. It took about 3 minutes of this shock treat
ment before the clutch plate freed off.
Tony
|
2208.11 | Is THAT what you were doing Tony? 8^) | CMOTEC::POWELL | Nostalgia isn't what it used to be, is it? | Mon Jan 24 1994 12:32 | 0 |
2208.12 | Sticking clutch kamikazesolution | KIRKTN::BHAILE | | Mon Feb 07 1994 03:03 | 10 |
| With reference to your clutch problem, I,ve heard of this solution but
never tried it...... Warm the engine up to normal temperature, jack the
car up putting all four corners on axle stands.Get the speedo up to
about 80mph, preferably in fourth then hit the brakes... and pray.I
have it on good authority that this works, but I have always avoided
the problem by keeping the clutch pedal depressed with a block of wood
during long term storage.
Goodluck, might be a good idea to have your garage door
open!
brian.
|
2208.13 | Well did yo free it or not Dougie | WELCLU::YOUNG | Policemen aren't nasty people | Fri Apr 15 1994 12:11 | 4 |
|
Well Dougie you never actually told us whether you free'd it and how!
Richard
|